Tuesday, November 23, 2010

Maytag French door service manual

Maytag french door service manual

Note this is the companion service manual to a post I did earlier about programming a maytag control board

Sunday, November 21, 2010

Maytag programming notes

You gotta program that board after the install. Here is the instructions:


Programming Mode:
NOTE: The Program Code is located on the Serial Plate on this unit
after the word Code.
1. Press and hold the Door Alarm Keypad .
2. Press and hold Freezer Temperature Down Keypad .
3. Release the Door Alarm Keypad and wait 3 seconds.
4. The control will display PE to indicate the programming mode.
5. Entry is confirmed by pressing the Freezer Temperature Down
Keypad once more.
6. The control will display the current Program CODE. This value
should be validated with the
Program CODE printed on the unit serial plate.
NOTE: If the Program CODE is correct, the Programming Mode is
exited by pressing Door Alarm
Keypad for 3 seconds.
7. Press the Refrigerator Temperature Up Keypad or Refrigerator
Down Keypad to
change the digit value with each key press.
8. The decimal point indicates the selected digit. Press the Freezer
Temperature Up Keypad to
select the next digit.
9. Once the desired Program CODE is entered, press and hold the
Freezer Temperature Down Keypad
until the Program CODE begins flashing indicating it has been saved.
NOTE: If you attempt to enter an invalid Program CODE the control
will not save the new code, but will
beep. (The unit will NOT run with a Program CODE of 0000).Once the
Program CODE has been
saved the Programming Mode is exited by pressing any key. If the
new code is incorrect this
process should be repeated.
The Programming mode can be exited at any time by pressing Door
Alarm key for 3 seconds or
will exit if unattended for four minutes. Got all that? LOL